ANALITICAL STUDY OF DYAMIC CUTTING FORCE COMPONENTS IN FACE MILLING
Keywords:
face milling, Cutting Forces, forces componentsAbstract
For an understanding of the cutting dynamics of face milling, the knowledge of the cutting forces is one of the most fundamental requirements. This knowledge also gives very important information for cutter design, machine tool design, and detection of tool wear and breakage. This paper presents experimentally obtained cutting force components patterns for one revolution during face milling. Measurement of cutting force and results presentation are done by data acquisition system set by authors. The virtual instrument used for measuring the cutting force during face milling was set by use of graphical programming software such as matlab. Results of experiments are presented in graphical forms and mathematical model for cutting forces components are determined. Influence of cutting speed, feed, and depth of cut on the cutting force orthogonal components are analyzed.